MIL-A-62463B(AT)
the right to perform or witness any of the inspections or tests set forth in the specification where
deemed necessary to assure supplies and services conform to prescribed requirements.
4.1.1 Inspection equipment. Unless otherwise specified in the contract, the contractor is
responsible for the provision and maintenance of all inspection and test equipment necessary to
assure that the supplies and services conform to contract requirements. Commercial, modified
commercial, or contractor designed equipment or measuring set-ups shall be capable of repetitive
measurements to an accuracy of 10 percent of the component tolerance.
4.1.2 Materials and construction. To determine conformance to 3.2 through 3.3.1, inspection
and material certification records shall be maintained by the contractor. Records shall be subject
to review by the Government and shall include date, part, or characteristic identification,
inspection results, and disposition of lot (accepted or rejected). Corrective action taken on noted
defects shall be subject to approval by the Government.
4.2 Classification of inspection:
a. First article inspection (see 4.4).
b. Quality conformance inspections (see 4.5).
1. Examination (see 4.5.2).
2. Acceptance tests (see 4.5.3.1).
3. Control tests (see 4.5.3.2).
4.3 Inspection conditions. All inspections and tests shall be conducted under the following
conditions:
a. Hydraulic fluid shall conform to grade 10 of MIL-L-2104, and be maintained at a
temperature of 90 °F ± 20 °F (32 °C ± 11 °C), except when otherwise specified.
b. Cleanliness of fluid shall conform to ISO code 19/16 as specified in SAE J1165.
4.3.1 Test equipment. The following test equipment shall be available for performance of the
tests and inspections specified herein:
a. Fixture(s) to securely hold and position an actuator under test. It shall be capable of
Restricting the movement of the shaft when test conditions require.
b. Hydraulic power source(s) capable of providing a minimum of 8000 psi (55160 kPa)
pressure at 1 gpm (3.8 Lpm) flow and 4500 psi (31030 kPa) pressure at 5 gpm (19 Lpm) flow.
c. Gages to measure pressure and beakers to measure leakage. The gages shall be accurate
within plus or minus 2 percent of full scale, and the beakers within plus or minus 5 percent of reading.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business