A-A-52168 - Cable And Conduit Assembly, Parking Brake-Straight Type, Button And Threaded Fittings
This commercial item description (CID) covers the general requirements for cable and conduit assembly, parking brake-straight type, button and threaded fittings. Cable and conduit assembly, parking brake-straight type, button and threaded fittings covered by this CID are intended for commercial/industrial applications.
A-A-52175 - Pistons, Hydraulic Brake, Wheel Cylinder: Sintered Iron (Metric)
A-A-52410 - Boot, Dust And Moisture Seal: Hydraulic Brake Cylinder, Synthetic Rubber
This CID covers brake boots used in covering the open ends of wheel and master cylinders in hydraulic brake systems of automobiles, trucks, and other wheeled vehicles employing hydraulic brake fluid of the nonpetroleum base type. Brake boots covered by this specification are intended for use as protective devices against dirt and moisture.
A-A-52431 - Evaporator, Alcohol - Air Brake System
This CID covers an alcohol evaporator used in air brake systems. The evaporator provides a means of inducing filtered air through the alcohol to form vapor for induction into the air compressor and brake system. The alcohol evaporator is also referred to herein as evaporator.
A-A-52448 - Cock, Plug: Air Supply, Vehicular, Air Brake System
This CID covers one type of plug cock, which is used in the vehicular air brake system.
A-A-52477 - Cable And Conduit Assembly, Parking Brake-Loop Type, Eye End Fitting (Metric)
This CID covers two sizes of parking brake cable and conduit assemblies with loop-type eye end fittings. The cable and conduit assembly is capable of withstanding a load of 910 kilogram (kg).
A-A-52485 - Valve, Relay Emergency: Breakaway Air Brake
This CID covers air operated relay emergency valve used in vehicle air brake systems referred to herein as relay valve.
A-A-52494 - Rubber Stock, Unvulcanized: For Track Shoes, Pads, And Pin Bushings (Metric)
This CID covers unvulcanized rubber stock intended for use in reconditioning rubberized track shoe assemblies for use on military tracked vehicles.
A-A-52500 - Cable And Conduit Assembly, Parking Brake-Loop Type, Button End Fitting (Metric)
This CID covers three sizes of parking brake cable and conduit assemblies with loop-type button end fittings. The cable and conduit assembly is capable of withstanding a load of 910 kilograms (Kg).
A-A-52522 - Lining Brake, And Lining Material Brake: Automotive (Metric)
This CID covers automotive brake lining sets and brake lining material used in commercial and military vehicles. Except for the following: heavy construction, heavy military, industrial aeronautical, and any other application where the friction material is compounded specifically for a special purpose vehicle.
A-A-52523 - Tank, Pressure: Air Brake, Tactical Trailers
This CID covers air pressure tanks of various capacities used in 125 pounds per square inch (psi) air brake systems of trailers.
A-A-57174 - Nut, Cap, Dual Wheel Mounting
This commercial item description covers dual wheel mounting cap, nut, which is used to mount and secure dual wheels on the vehicle's axle.
HH-L-361 - Lining, Brake; And Lining Material, Brake: Automotive (S/S By A-A-52522)
MIL-A-14430 - Axle And Bushing Assembly For Bogie For Carriage, Gun, 155Mm, M1 And Carriage, Howitzer, 8-Inch, M1 Packaging Of.
MIL-A-62463 - Actuator Assembly, Rotary
This specification covers two types of rotary actuator assemblies unique to the suspension of the Armored Combat Earthmover, M9 ACE.
MIL-B-22182 - Brake, Parking, Mobile Ground Support Equipment
MIL-B-45326 - Boot, Dust And Moisture Seal: Hydraulic Brade Cylinder, Synthetic Rubber (S/S By A-A-52410)
MIL-D-46760 - Drawbar Assembly For Transporter, Liquid, Rolling Wheel Type, 1,000 Gallon, M6
MIL-DTL-11891 - Track Shoe Sets, Track Shoe Assemblies, Track Shoe Pads And Track Shoe Bushings, Vehicular: Elastomerized
This specification identifies the requirements for qualification and production control of track systems supporting U.S. Military Tracked Vehicles. This specification is intended primarily for the qualification of elastomeric compounds used in the fabrication of track and track components and to ensure that the quality and performance established at qualification is maintained throughout production. The contractor is held fully responsible for the entire assembly/component including all non-elastomeric components and fasteners.
MIL-DTL-13719 - Hose And Hose Assembly, Rubber, Hydraulic Brake, Type I And Type Ii
This specification covers hose and hose assembly, rubber, hydraulic brake, type I and type II.
MIL-DTL-14055 - Cup, Hydraulic Brake Actuating Cylinder: Synthetic Rubber
This specification covers molded cups, 2 inches in diameter and under, compounded from high temperature resistant rubber for use in hydraulic actuating cylinders employing hydraulic brake fluid of non-mineral oil type.
MIL-DTL-45334 - Compressor Assemblies, Airbrake System; Wheeled Vehicle
This specification covers eight types of air compressors for airbrake systems of military wheeled vehicles. This specification also covers accessory governors and air cleaners for type I and type II compressors (see 6.1).
MIL-DTL-62460 - Steer Unit, Tracked Vehicle, Clutch Brake And Geared Steer
The steer unit covered by this specification is intended for use as a steer unit for the Armored Combat Earthmover M9 ACE. The steer unit is a two-speed, double-output gearbox, manually controlled for manipulating track laying vehicles, and includes a bevel gear set, clutch brake and geared steering systems, and full vehicle brakes.
MIL-DTL-62567 - Torsion, Bar, Suspension
This specification covers a military combat vehicle suspension torsion bar.
MIL-M-45347 - Magnesium Alloy Wheel, Components, Treatment And Painting Of (S/S By Mil-Std-193)
MIL-P-11349 - Plate, Street, Tractor (Half Set For Caterpillar D-7, 22 Inch, Grouser Shoe).
MIL-P-62108 - Pistons, Hydraulic Brake, Wheel Cylinder: Sintered Iron (S/S By A-A-52175)
This specification covers fluid-impregnated (non-petroleum type), sintered iron pistons used in wheel cylinders of hydraulic brake systems (see 6.1).
MIL-PRF-62136 - Wheel And Tire Assemblies, Foam Inflated Low Speed, Highway And Off-Road
This specification covers foam inflated, wheel and tire assemblies for mounting on low speed airstrip loaders and off-the-road forklifts.
MIL-PRF-62364 - Brake, Electromagnetic, Normally Engaged
This specification covers two types of electromagnetic brake assemblies. Each, when electrically energized, releases a shaft to permit motion. When de-energized, the brake assemblies apply braking to the driving shaft to arrest its motion.
MIL-R-46762 - Rubber Stock, Unvulcanized: For Track Shoes, Pads, And Pin Bushings (S/S By A-A-52494)
This specification covers unvulcanized rubber stock used for reconditioning rubberized track shoe assemblies for use on military tracked vehicles. (see 6.1).
MIL-S-11382 - Shoe, Tractor Mounting, Railroad Grouser (Integral, Full Set).
MIL-S-22003 - Suspension Units, - Individual, For Mobile Ground Support Equipment
MIL-S-45387 - Springs, Torsion Bar, Suspension
This specification covers straight, solid, circular cross-section, torsion-bar springs.
MIL-T-62196 - Track Shoe Assemblies; Replacement Of Rubber Components And Overhaul Of T97E2 (See Notice 1 For Replacement Information)
MIL-V-46704 - Valve, Relay, Emergency: Breakaway Air Brake (S/S By A-A-52485)
This specification covers the minimum requirements for an air operated relay emergency valve used in vehicle air brake systems.
MIL-W-21985 - Wheel - Cushion Tread (Semi-Pneumatic) For Mobile Ground Support Equipment (S/S By Sae-As21985)
This specification covers one type of cushion tread (semi-pneumatic) wheels for use on mobile ground support equipment.
MIL-W-46740 - Wheel, Fuel Cell
MS24322 - Wheels And Hub Assemblies (S/S By A-A-59494)
MS24323 - Wheel, Pneumatic Tire, 3.50-6 (S/S By A-A-59494)
MS24324 - Wheel, Pneumatic Tire, 4.00-8 (S/S By A-A-59494)
MS24325 - ( Images) Wheel For 6.00-9 Tire (S/S By A-A-59494)
MS24326 - ( Images) Wheel For 7.50-10 & 9.00-10 Tires (S/S By A-A-59494)
MS24327 - ( Images) Hub-Cantilever Mounting For 3.50-6 And 4.00-8 Wheels (S/S By A-A-59494)
MS24328 - ( Images) Hub-Cantilever Mounting For 6.00-9, 7.50-10 And 9.00-10 Wheels (S/S By A-A-59494)
MS24329 - Hub, Assembly, Fork Mounting, For 3.50 And 4.00-8 Wheels (S/S By A-A-59494)
MS24330 - ( Images) Hub, Assembly, Fork Mounting, For 6.00-9 And 7.50-10 Wheels (S/S By A-A-59494)
MS35747 - Holder, Spring, Air Brake Hose Coupling
MS35749 - Spring, Helical, Compression, Air Brake Hose Coupling
MS35750 - Plunger, Air Brake Hose Coupling
MS35865 - Axle, Vehicular, Non-Driving, Single For Tactical Wheeled Vehicles
MS35866 - Axle Assembly, Vehicular Non Driving, Tandem For Tactical Wheeled Vehicles
MS500046 - ( Images) Cock, Plug Air Supply, Vehicular, Air Brake System (S/S By A-A-52448)
MS500093 - ( Images) Tank, Pressure, Air Brake, Tactical Trailers (S/S By A-A-52523)
MS51002 - Brake Shoe, Internally Actuated, W/Lining Assembly - 15 X 3
MS51003 - Brake Shoe, Internally Actuated, W/Lining Assembly - 16-1/2 X 5-1/2
MS51322 - ( Images) Compressor, Reciprocating Power Driven, Air Cooled, 7-1/4 C.F.M., W/Unloader (S/S By Mil-Prf-45334)
MS51328 - Connecting Link, Rigid, Straight
MS53004 - ( Images) Valve, Relay, Emergency - Breakaway, Air Brake (S/S By A-A-52485)
MS53005 - ( Images) Air Cleaner, Intake: Compressor (S/S By Mil-Prf-45334)
MS53006 - ( Images) Governor Assembly: Air Brake For Tactical Vehicles (S/S By Mil-Prf-45334)
MS53032 - ( Images) Compressor, Reciprocating, Power Driven: Air Cooled, 12 C.F.M. W/Unloader (S/S By Mil-Prf-45334)
MS53044 - ( Images) Wheel, Pneumatic Tire-Disk Type, With Ring, For Tactical Wheeled Vehicles
MS53045 - ( Images) Ring, Side, Automotive Wheel For Tactical Wheeled Vehicles (S/S By A-A-59157)
MS53058 - ( Images) Cable And Conduit Assembly, Parking Brake-Loop Type, Button End Fitting (S/S By A-A-52500)
MS53059 - Cable And Conduit Assembly, Parking, Brake-Loop Type, Eye End Fitting (S/S By A-A-52477)
MS53060 - Cable And Conduit Assembly, Parking Brake-Straight Type, Button And Threaded Fittings (S/S By A-A-52168)
MS53061 - ( Images) Cable And Conduit Assembly, Parking Brake-Straight Type, Eye And Threaded Fittings
MS53062 - ( Images) Cable And Conduit Assembly, Parking Brake - Straight Type, Eye And Button Fittings
MS53067 - ( Images) Evaporator, Alcohol - Air Brake System (S/S By A-A-52431)
MS53068 - ( Images) Nut, Cap, Dual Wheel Mounting (S/S By A-A-57174)
QPL-11891-25 - Track Shoe Sets, Track Shoe Assemblies, Track Shoe Pads And Track Shoe Bushings, Vehicular: Elastomerized (Replaced By The Qualified Products Database (Qpd) See Notice 1 For Additional Information)
QPL-13719-13 - Hose Assembly, Rubber, Hydraulic Brake (S/S By Mil-Prf-13719)
QPL-14055-13 - Cup, Hydraulic Brake Actuating Cylinder: Synthetic Rubber, General Specification For (Replaced By The Qualified Products Database (Qpd) See Notice 1 For Additional Information)
QPL-45326 - Boot, Dust And Moisture Seal, Hydraulic Brake Cylinder, Synthetic Rubber
QPL-45334-6 - Compressors, Assemblies, Airbrake System; Wheeled Vehicle
QPL-46762 - Rubber Stock, Unvulcanized, For Track Shoes Pads And Pin Bushings (Not Yet Published)
QPL-7782-2 - Wheel Aircraft Tail Solid Rubber Tire
QPL-8005-10 - Wheels And Hubs, For Industrial Pneumatic Tires
ZZ-C-746 - Cup, Hydraulic, Brake, Natural Rubber
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business