INCH-POUND
MIL-DTL-14055G
1 May 2014
SUPERSEDING
MIL-DTL-14055F
17 August 2011
DETAIL SPECIFICATION
CUP, HYDRAULIC BRAKE ACTUATING CYLINDER: SYNTHETIC RUBBER
Inactive for new design after 22 January 1999.
This specification is approved for use by all Departments and Agencies
of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers molded cups, 2 inches in diameter and under, compounded from
high temperature resistant rubber for use in hydraulic actuating cylinders employing hydraulic brake fluid
of non-mineral oil type.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification.
This section does not include documents cited in other sections of this specification or recommended for
additional information or as examples. While every effort has been made to ensure the completeness of
this list, document users are cautioned that they must meet all specified requirements of documents cited
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks
form a part of this document to the extent specified herein. Unless otherwise specified, the issues of
these documents are those cited in the solicitation or contract.
FEDERAL STANDARD
FED-STD-791 - Lubricants, Liquid Fuels, and related Products; Methods of Testing
DEPARTMENT OF DEFENSE SPECIFICATIONS
MIL-PRF-46176 - Brake Fluid, Silicone, Automotive, All Weather, Operational and Preservative
Comments, suggestions, or questions on this document should be addressed to: DLA Land and Maritime, Attn:
VAI, P.O. Box 3990, Columbus, OH 43218-3990, or emailed to FluidFlow@dla.mil. Since contact information
can change, you may want to verify the currency of this address information using the ASSIST Online database
AMSC N/A
FSC 2530
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business