A-A-57174A
d. The nut, cap shall resist the load without failure such as stripping or rupture, and shall
be removable by hand after load is released.
NOTE: It may be necessary to use a manual wrench or other means to start nut, cap in
motion after load has been released to remove nut, cap. Such wrenching is
permissible providing that it is restricted to one half turn.
2.4 Markings. Markings shall be in accordance with MIL-STD-130. The location of the part
marking shall be as shown in figure 1.
2.5 Workmanship. The nut, cap shall be free from burrs, cracks, sharp edges, irregularities, and
any other defects affecting serviceability or appearance.
3. REGULATORY REQUIREMENTS.
3.1 Recovered materiel. Recycled, recovered, or environmentally preferable materials should be
used to the maximum extent possible provided that the material meets or exceeds the operational
and maintenance requirements, and promotes economically advantageous life cycle costs. The
offeror/contractor is encouraged to use recovered materials to the maximum extent practicable,
in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
4. PRODUCT CONFORMANCE PROVISIONS.
4.1 Responsibility for inspection. The contractor is responsible for the performance of all
inspections (examinations and tests).
4.2 Contractor certification. The contractor shall certify and maintain substantiating evidence
that the product offered meets the salient characteristics of this CID and that the product
conforms to the producers own drawings, specifications, standards, and quality assurance
practices. Items with known defects shall not be submitted for Government acceptance. The
Government reserves the right to require proof of such conformance prior to the first delivery
and thereafter as may be otherwise provided for under the provisions of the contract.
5. PACKAGING. Preservation, packaging, packing, labeling, and marking shall be as specified
in the contract or purchase order (see 6.2).
6. NOTES. This section contains information of a general or explanatory nature that may be
helpful, but is not mandatory.
6.1 Source of documents.
6.1.1 Government specifications and standards. Copies of federal and military specifications
and standards are available from the Navy Publications and Printing Service Office,
Standardization Documents Order Desk, Bldg. 4D, 700 Robbins Avenue, Philadelphia,
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business