A-A-52500
2.5 Performance. The cable and conduit assembly shall be capable of operation down to -54°C (see 5.2).
Each cable and conduit assembly shall be pre-stretched under a load of 454 kg. The cable assembly shall
be capable of withstanding a load of 910 kg. sustained for a period of two hours with a maximum
permissible slippage of each end fitting with respect to the cable of 0.4 millimeter (mm). With load
applied, the cable outer sheath shall not show any lateral displacement or permanent deformation of
conduit. The outside diameters of conduit coils shall remain in-line.
2.6 Identification markings. Identification markings shall be permanent and legible and shall include, as a
minimum, the manufacturer's CAGE code and part number, and the part identification number (PIN)
(see figure 1 and 5.3).
3. QUALITY ASSURANCE PROVISIONS.
3.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections
(examinations and tests).
3.2 Contractor certification. The contractor shall certify and maintain substantiating evidence that the
product offered meets the salient characteristics of this commercial item description and that the product
conforms to the producer's own drawings, specifications, workmanship standards, and quality assurance
practices. Item with known defects shall not be submitted for Government acceptance. The Government
reserves the right to require proof of such conformance prior to the first delivery and thereafter as may be
otherwise provided for under the provisions of the contract.
4. PRESERVATION, PACKAGING, PACKING, LABELING, AND MARKING. Preservation,
packaging, packing, labeling, and marking for the desired level shall be as specified in the contract
(see 5.2).
5. NOTES. (This section contains information of a general or explanatory nature that may be helpful, but
is not mandatory.)
5.1 Addresses for obtaining copies of referenced documents.
5.1.1 Government specifications. Copies of MIL-G-23827 "Grease, Aircraft and Instrument, Gear and
Actuator Screw" are available from the Defense Printing Service Detachment Office, Bldg. 4D
(Customer Service), 700 Robbins Avenue, Philadelphia, PA 19111-5094.
5.1.2 Industry specifications. Copies of ASTM B633 "Standard Specification for Electrodeposited
Coatings of Zinc on Iron and Steel" are available from the American Society for Testing and Materials,
1916 Race Street, Philadephia, PA 19103.
5.2 Ordering data. Acquisition documents must specify the following:
a.
Title, number, and date of this CID.
b.
Part or identification number (PIN).
c.
Selection of applicable level and packaging requirements.
Use of MIL-G-23827 for grease lubricant when operating temperature is lower than -54°C.
d.
e.
Issue of Department of Defense Index of specifications and standards (DoDISS) to be cited in
the solicitation, and if required, the specific issue of individual documents referenced.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business