A-A-52477
3. QUALITY ASSURANCE PROVISIONS.
3.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections
(examinations and tests).
3.2 Contractor certification. The contractor shall certify and maintain substantiating evidence that the
product offered meets the salient characteristics of this CID and that the product conforms to the
producer's own drawings, specifications, workmanship standards, and quality assurance practices. Items
with known defects shall not be submitted for Government acceptance. The Government reserves the right
to require proof of such conformance prior to the first delivery and thereafter as may be otherwise
provided for under the provisions of the contract.
4. PRESERVATION, PACKAGING, PACKING, LABELING, AND MARKING. Preservation,
packaging, packing, labeling, and marking shall be as specified in the contract or order (see note 5.2).
5. NOTES. (This section contains information of a general or explanatory nature that may be helpful but
is not mandatory.)
5.1 Addresses for obtaining copies of referenced documents.
5.1.1 Government specifications. Copies of MIL-G-23827 "Grease, Aircraft and Instrument, Gear and
Actuator Screw" are available from the Navy Publication and Printing Service Office, Standardization
Documents Order Desk, Bldg. 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.
5.1.2 Industry specifications. Copies of ASTM B633 "Standard Specification for Electrodeposited
Coatings of Zinc on Iron and Steel" are available from the American Society for Testing Materials,
1916 Race Street, Philadelphia, PA 19103.
5.2 Ordering data. Acquisition documents must specify the following:
a. Title, number, and date of this CID.
b. Issue of Department of Defense Index of Specifications and Standards (DODISS) to be cited in
the solicitation and, if required, the specific issue of individual documents referenced.
c. Part or identification number (PIN).
d. Selection of applicable level and packaging requirements.
e. When temperature is lower than -54°C use MIL-G-23827 for grease lubricant.
5.3 Part identification number (PIN). The PINs to be used for cable and conduit assemblies acquired to
this CID are created as follows:
A 52477 - X
Number designation for size (see figure 1).
CID number.
Designates a CID.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business