INCH-POUND
MIL-DTL-62567D(AT)
8 April 2010
SUPERSEDING
MIL-DTL-62567C(AT)
16 September 1998
DETAIL SPECIFICATION
TORSION BAR, SUSPENSION
This specification is approved for use by the U.S. Army Tank Automotive Research,
Development and Engineering Center (TARDEC), Research, Development and
Engineering Command (RDECOM), Department of the Army, and is available for
use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers a military combat vehicle suspension torsion bar.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3, 4 or 5 of
this specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements of documents cited in sections 3, 4 or 5 of this specification,
whether or not they are listed.
2.2 Government documents.
2.2.1 Government documents, drawings, and publications. The following Government
documents, drawings, and publications form a part of this document to the extent specified
herein. Unless otherwise specified, the issues are those cited in the solicitation or contract
(see 6.2).
Comments, suggestions, or questions on this document should be addressed to
U.S. Army RDECOM, Tank Automotive Research, Development and Engineering Center,
ATTN: RDTA-EN/STND/TRANS MS #268, 6501 E. 11 Mile Road, Warren, MI 48397-5000
or emailed to DAMI_STANDARDIZATION@conus.army.mil. Since contact information can
change, you may want to verify the currency of this address information using the ASSIST
Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 2530
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business